Manual

STE-1430 1 Installation Guide
Installation Guide
Mounting and Wiring
The STE-1430 is a blank, stainless-steel wall plate
that incorporates a precision sensor used to monitor
room temperatures where additional security is
required (e.g., against vandalism).
It is designed to be mounted directly to a single-gang
electrical box. Insulating foam is adhered to the back
of the wall plate to provide a thermal barrier from
internal wall temperatures. The STE-1430 should
be installed where it can sense the average room
temperature and be unaected by direct sunlight
and drafts.
1. Feed the cable wires through the conduit or hole
opening.
2. Make connections to the two sensor wire leads
with either bu-splices or solder. (Using wire
nuts is not recommended.) The two-wire sensor
is not polarity sensitive.
3. Plug the conduit with plumber’s puy, painter’s
puy, caulk, or other sealant to prevent air
inltration.
4. Aach the sensor panel to the electrical box using
the two supplied #6 screws.
Contents
Mounting and Wiring 1
Configuration 1
Specifications 1
Maintenance 1
More Information 2
Important Notices 2
Room Temperature Sensor (Flat Plate)
STE-1430
2.75"
69.85 mm
4.5"
114.3 mm
0.1875"
4.75 mm
3.375"
85.73 mm
Specifications
Sensor Type III thermistor, 10K ohm
@ 77° F (25° C)
Temperature Limits –4 to 221° F (–20 to 105° C)
Wiring 22 AWG wire leads
Dimensions 2-3/4 x 4-1/2 inches (70 x 114
mm)
Finish Brushed stainless steel
Configuration
For controller conguration, see the Type III Sensors
Applications Guide on the KMC web site.
Maintenance
No routine maintenance is required. Each compo-
nent is designed for dependable, long-term reliability
and performance. Careful installation will also
ensure long term reliability and performance.