Application Guide

Type III Temperature Sensors 3 Applications Guide, AN1013A Rev. B
Important Notices
The KMC logo and KMC Controls are registered
trademarks of KMC Controls, Inc.
All rights reserved. No part of this publication may
be reproduced, transmied, transcribed, stored in a
retrieval system, or translated into any language in
any form by any means without the wrien permis-
sion of KMC Controls, Inc.
The material in this document is for information
purposes only. The contents and the product it
describes are subject to change without notice.
KMC Controls, Inc. makes no representations or
warranties with respect to this document. In no event
shall KMC Controls, Inc. be liable for any damages,
direct or incidental, arising out of or related to the
use of this document.
KMC Controls, Inc.
19476 Industrial Drive
New Paris, IN 46553
574.831.5250
www.kmccontrols.com
[e-mail]
Maintenance
No routine maintenance is required. Each compo-
nent is designed for dependable, long-term reliabil-
ity and performance. Careful installation will also
ensure long-term reliability and performance.
© 2014 KMC Controls, Inc. AN1013A Rev. B
WinControl Software
1. In the WinControl software main menu, select
Control > Inputs.
2. Click Edit.
3. Type in a name in the appropriate Description
eld (up to 20 characters) and/or Label eld (up to
8 characters).
NOTE: No two labels or descriptions in a controller
can be identical.
4. Click Units (which opens the Congure Inputs
screen).
5. Select Type: Analog if it is not the default.
6. Select Deg F (or C) KMC10K Type III.
7. Optionally, change Format from 0 to the desired
number of temperature decimal places.
8. Optionally, change the Average to the desired
number of thermistor readings averaged before
displaying the result.
9. Click OK.
10. Click End Edit.
11. Click OK.
TotalControl Software
NOTE: Follow the relevant hardware instructions
in the BACstage Software section or
WinControl Software section. Then see
the TotalControl Help information for
the equivalent software conguration in
TotalControl.
NOTE: TotalControl assumes the Type III
thermistor table is in Table 3 of the Building
Controller.