Product Overview

ManualsBrandsKMC Controls ManualsRelayREE-1005

Table Of Contents

Speciﬁcations

Supply Voltage 9.1 to 18 VDC (2 mA)

Contact Voltage On Normally Closed (NC),

Normally Open (NO), and

Common (C), supply voltage

minus 1 VDC

Setpoint 77 ±4° F (25 ±2° C)

Connections Plated screw terminals

Wire Size 14 to 22 AWG, stranded

Material Flame-retardant plastic

Weight

2 oz. (57 grams)

Approvals SASO PCP Registration KSA

R-103263

Temperature Limits

Operating 40 to 120° F (4 to 49° C)

Shipping –40 to 140° F (–40 to 60° C)

Description

The KMC REE-1005 Relay Module is designed

primarily for automatic heating/cooling changeover

applications on single-duct VAV terminal units in

HVAC systems.

Used with SSE-2000 series sensors, the REE-1005 has

the ability to change the action of the VAV terminal

to either heating or cooling based on the temperature

of the supply air to the VAV terminal.

REE-1005 Relay Modules are intended for use with

the following:

Associated Controllers-Actuators:

CEE-4000 Series

CEP-4000 Series

CSE-4000 Series

CSP-4000 Series

CSP-5001/5002

Associated Thermostats:

CEE-1103

CTE-1004

CTE-1103

CTE-5103

CTE-5104

Associated Duct Sensors:

SSE-2000 Series

TTE-2001

REE-1005

Relay Module, Heat/Cool Changeover

Features

◆ Automatic Heat/Cool changeover

◆ Optional auxiliary ow trigger control (from

Terminal A)

◆ Simple installation

Description 1

Features 1

Speciﬁcations 1

Details 2

Speciﬁcations and design subject to change without notice.

NOTE: See the CEP-4000 Series Applications

Guide and the CSP-5001/5002 Applications

Guide for additional information on

applications.

Summary of content (2 pages)

PAGE 1
REE-1005 Relay Module, Heat/Cool Changeover Description The KMC REE-1005 Relay Module is designed primarily for automatic heating/cooling changeover applications on single-duct VAV terminal units in HVAC systems. Used with SSE-2000 series sensors, the REE-1005 has the ability to change the action of the VAV terminal to either heating or cooling based on the temperature of the supply air to the VAV terminal.
PAGE 2
Details All dimensions are in inches (mm) NOTE: Terminal A is an optional auxiliary flow limit trigger signal (usually connected to Terminal A on a CTE-1004, CTE-5104, or REE-1012). When the relay module senses heating mode, terminal A goes high (around 6.8 VDC with a 9.1 VDC supply or 13.8 VDC with a 16 VDC supply). This terminal can also be used to daisy chain more than one REE-1005 together by wiring Terminal “A” to Terminal “Y” on the next relay. KMC Controls, Inc.