Owner's manual

MEP-4101 1 Installation Guide
Installation Guide
Direct-Coupled ControlSet
®
Actuator (10 in-lb.)
MEP-4101
Mounting 1
Wiring 2
Maintenance 2
Accessories 2
Specifications 2
Mounting
1. Ensurethedampercan
movefreelythroughits
entirerangeofmotion,
andxanybinding
beforeinstallingthe
actuator.Turnthe
damperbladetoits
fullyclosedposition.
2. Press(totheright)
andholdthegear
disengagementlever
(seetheillustration),
rotatetheactuatortothe
fullyclosedposition,
andreleasethelever.
NOTE: Dependingon
thedamper-seal
design,backing
theactuator
oitsstop
approximately5°
mayprovidetight
dampershut-o.
3. Aligntheactuatorand
slideitontothesha.
4. Leavingagapbetween
theactuatorand
mountingsurfaceto
preventanybinding,
nger-tightenthenuts
ontheV-bolt.
5a.Insertthenon-rotation
bracket(HMO-4002
suppliedorHMO-4001
“T”bracketavailable
separately)intothe
slotatthebaseofthe
actuatorandsecurethe
non-rotationbracket
withtwo#8or#10self-
tappingscrews.(This
istherecommended
method.)
5.313
135
3.844
97.6
1.281
32.5
0.204
0.194
5.18
4.93
LEDs VISIBLE UNDER TRANSLUCENT COVER
GREEN: POWER OPEN (CCW DIRECTION)
RED: POWER CLOSED (CW DIRECTION)
ADJUSTABLE
STOP
1.568
40
[63.5]
2.500
2.600
66
GEAR
DISENGAGEMENT
LEVER
All dimensions are in inches (mm)
HMO-4002
Non-rotation
Bracket (Provided)