Owner manual

KMC ControlsKMD–1162 Installation and Operation

Models

Almond KMD-1162-10

White KMD-1162W10

Network Cable Preparation

Connecting a NetSensor to a KMC controller requires a six-wire cable

with RJ-12 connectors on each end. Use either the KMC Controls

ready-to-use cables or make cables to length when the NetSensor is

installed. Cables made to length must meet the following

requirements:

◆ Cable length is no longer than 75 feet (22.9 meters).

◆ Use cable with #24 AWG size conductors.

◆ Cable insulation must meet local building codes. Plenum rated

cable is recommended.

◆ Connectors are appropriate for the cable in use and are installed

following the connector manufactures instructions.

Cable Details

RJ-12