Product Overview

3
Accessories
Cables
HSO-5012 Thermostat plenum cable, 50 .,
with RJ-12 plug on one end and
stripped/tinned wires on the
other end
HSO-22xx
Modular thermostat plenum
cables, RJ-12 plug on both ends
(see the table below and the
sample application on the pre-
vious page for the appropriate
part number)
© 2012 KMC Controls, Inc.; KMC Controls
®
is a registered trademark of KMC Controls 821-035-01A
KMC Controls, Inc.
19476 Industrial Drive
New Paris, IN 46553
574.831.5250
www.kmccontrols.com
[e-mail]
Miscellaneous
HMO-1161 4 x 4 inch mounting backplate,
light almond
HPO-0044 Replacement cover hex screws
HPO-1161 Foam insulating gasket
MEP-4042/4842 Modular actuators
SP-001 KMC-branded screwdriver with
at blade and 1/16" hex end for
cover screws
Cable P/N
Cable
Length
Max. # of Daisy-Chained MEP-4x42s
WithOUT
HSO-5010
WITH
HSO-5010
HSO-2203 3 feet 6 12
HSO-2206 6 feet 6 12
HSO-2212 12 feet 6 12
HSO-2220 20 feet 4 8
HSO-2250 50 feet 2 4
Operation
Turn On Backlight
Pressing any buon turns on the backlight, which
will remain on until about nine seconds aer the last
buon press.
Change Setpoint
To change the setpoint, push the Setpoint buon to
display the current value. Use the Up/Down buons
to change the value. Aer the display reverts back
(aer about nine seconds) to displaying the room
temperature, the thermostat will control at the new
setpoint.
NOTE: Aer a power loss, the setpoint will revert
to the default value (70° F or 21.1° C is the
factory default). This default value is also
used in the deadband unoccupied mode. To
change the default value, see the CTE-5201
Installation Guide.
Start Unoccupied Mode
Flip open the cover (hinged on the le side)
and momentarily push the UNOCC buon. The
thermostat will stay in Unoccupied mode until the
Setpoint buon or one of the Up/Down buons are
pushed.
NOTE: There are two unoccupied mode options,
O (the default) or Deadband. See the CTE-
5201 Installation Guide for details.
Toggle Between °F and °C
To temporarily view the other temperature scale,
ip open the cover (hinged on the le side), and
momentarily press the F/C buon. The alternative
scale will appear as long as the backlight is on.
To make the desired F or C scale mode permanent
(the scale persists instead of being momentary), press
and hold the F/C buon down for approximately 10
seconds until the display begins to ash. To return to
the previous scale mode, repeat the process.