Install Instructions
Table Of Contents
- Contents
- Section 1: About the controllers
- Section 2: Installing the controllers
- Section 3: Changing the room setpoint
- Section 4: Configuring the controllers
- Section 5: Balancing airflow
- Section 6: Application drawings
- Section 7: Sequences of operation
- Section 8: System integration and networking
- Appendix A: K-factors
- Index
Dual-duct application
This application is for a BAC-8007 controller. The controller is configured for dual-duct
operation. Dual-duct VAV requires a TSP-8001 actuator to be used with the BC-8007 as
shown in the illustration Dual-duct wiring diagram on page 50.
Submittal sheets for several variations of this application are available from the Resources
page at www.SimplyVAV.com.
Illustration 6–6 Dual-duct wiring diagram
ON CTS
1 2
COMM
READY
AI1
AI5
GND
AO4
AO3
SC
BO8
BO5
BO6
SC
BO7
24VAC
AI6
GND
AI7
T-STAT/
SENSOR
-A
+B
S
EOL
BACnet MS/TP
P2
CW
COM
P1
CCW
24VAC
P OUT
MOTOR
F.B.
POT
24 VAC
BAC-8007
TSP-8001
SimplyVAV Section 6: Application drawings
Revision G 50