Installation Guide Manual

Procedure Detailed steps STE display
2 Select the restore settings
display.
1.
From the CNFG display, press the or
buttons to show the CNFG display.
2.
Press the
Set
Point
button to select the CNFG options.
The display changes to STPT.
3.
Press the or buttons to change the
display to RSTR.
Caution: Choosing RSTR deletes all
previously entered values and returns the
controller to the manufacturer's settings. Only
the BACnet communications settings will
remain unchanged.
4.
Press the
Set
Point
button to select RSTR.
CNFG
STPT
RSTR
3 Choose the application.
1.
Press the or buttons to choose ENGLISH
or METRIC.
Metric The sensor displays temperature in
Celsius and uses metric values for units of
measure.
English The sensor displays temperature in
Fahrenheit and uses English values for units of
measure.
2.
Press the
Set
Point
button to save the entry and
advance to the next function.
METRIC
RSTR
ENGLISH
RSTR
Procedure to restore application (continued)
SimplyVAV Section 4: Configuring the controllers
Revision E 41