Installation Guide Manual

Procedure Steps STE display
2 Enter Password 1.
1.
Press any button. The display changes to
PSW1.
2.
Press the or buttons to change the first
digit.
3.
Press the
Set
Point
button to select the next digit.
Repeat for all four digits.
Note: If Password 1 has not previously been
entered, the display will change to the
occupied cooling setpoint display after Step 1.
PSW1
OOOO
3 Set the active cooling
setpoint.
1.
Press the or buttons to change the
cooling setpoint temperature. The setpoint
changes in increments of 0.5 degrees.
2.
Press the
Set
Point
button to save the value.
The display advances to set the heating
setpoint.
745
COOLING
4 Set the active heating
setpoint.
1.
Press the or buttons to change the
heating setpoint temperature. The setpoint
changes in increments of 0.5 degrees.
2.
Press the
Set
Point
button to save the value.
The display returns to the temperature
display.
685
HEATING
Changing room setpoints (continued)
Section 3: Changing the room setpoint SimplyVAV
24 Revision E