Install Instructions
Table Of Contents
- Contents
- Section 1: About the controllers
- Section 2: Installing the controllers
- Section 3: Changing the room setpoint
- Section 4: Configuring the controllers
- Section 5: Balancing airflow
- Section 6: Application drawings
- Section 7: Sequences of operation
- Section 8: System integration and networking
- Appendix A: K-factors
- Index
Object Name Description
BV6 MOTION SENSOR Motion Sensor (Wall Stat)
BV7 NEED HOTTER SPLY Need For Hotter Air Supply
BV8 CHANGE OVER MODE SAT Changeover Mode
BV9 DAT LIMITING Discharge Air Temp Limiting
BV10 CLOCKWISE CLOSE Clockwise Close
BV11 AUTO OCCUPANCY Auto Occupancy Detection
BV12 BALANCE MODE Balance Mode
BV13 DAT SENSOR DAT Sensor Present
BV14 PRI BAL TRIGGER Primary Balance Trigger
Binary value objcts (continued)
Object Name Description
MSV1 OCCUPIED MODE Occupied Mode
MSV2 FAN CONFIG Fantype Configuration
MSV3 REHEAT Reheat Type
MSV6 WALL SENSOR Multi-state Value #6
Table 8–6 Multistate value objects
Loop objects
BACnet PID loops are used for modulating the damper and controlling reheat.
Loop Name Description
LOOP1 CL LOOP Cooling Loop
LOOP2 HT LOOP Heating Loop
LOOP3 DAT Loop Discharge Air Temp Loop
Table 8–7 PID control loop objects
SimplyVAV Section 8: System integration and networking
Revision G 71