Install Instructions

Restore Application
Choose the RSTR function to reset the SimplyVAV controller to the original configuration and
settings. Use it also to change the units of measure to display on a SimplyVAV sensor.
There are two versions of the application program in the controller.
l The Metric version displays temperature in Celsius and uses metric values for units of
measure.
l The English version displays temperature in Fahrenheit and uses English values for
units of measure.
Access to the Restore Application function requires entering Password 2 which is described
in the topic Getting started with configuration on page 24.
Tip: Once the following procedure is started, all steps must be completed in order.
Caution
Choosing RSTR deletes all previously configured values
including balancing values and passwords. Only the
BACnet communications settings will remain unchanged.
Procedure Detailed steps STE display
1 Starting display
1. Start at the temperature display.
2. Press the and buttons together.
l If Password 2 is not required, the display
changes to CNFG.
l If required, enter Password 2. The display
changes to CNFG when Password 2 is
correct.
72
12S1
PSW2
OOOO
2 Select the restore settings
display.
1. From the CNFG display, press the or
buttons to show the CNFG display.
2. Press the
Set
Point
button to select the CNFG options.
The display changes to STPT.
CNFG
STPT
Procedure to restore application
Section 4: Configuring the controllers KMC Controls, Inc.
38 Revision G