Install Instructions

Specifications
SimplyVAV specifications are subject to change without notice.
Inputs and outputs
All inputs and outputs are factory programmed and application specific. No field
configuration is required. For details on input and output connections, see the topic
Application drawings on page 44. For a detailed listing of input and output objects, see the
topic BACnet objects on page 68.
Analog inputs
Analog inputs represent BACnet analog input. Not all input are applicable or required for all
models.
Key features Standard units of measure.
Overvoltage input protection
Connectors RJ-45 room sensor jack
Screw terminals for wire sizes 12-26 AWG
Conversion 12–bit analog–to–digital conversion
Input range Passive, 10 kΩ pull-up to 3.3 volts DC
Analog outputs
Analog outputs are configured to represent BACnet analog output objects. No field
configuration is required. For details on application specific output connections see the
section Application drawings on page 44.
Key features Output short protection
Standard units of measure
Connector Screw terminals for wire size 12-26AWG
Conversion 12–bit digital-to-analog conversion
Output voltage 0–10 VDC
Output current 30 mA per output, 30 mA total for all analog outputs
Binary outputs
Binary outputs are configured to represent BACnet binary output objects. No field
configuration is required. For details on application specific output connections see the
section Application drawings on page 44.
Key features Optically isolated triac output
Connector Screw terminals for wire size 12-26 AWG
Output range Maximum switching 24 Volts AC
1 ampere per external output, 3 amperes total
SimplyVAV Section 1: About the controllers
Revision G 7