Install Instructions
Table Of Contents
- Contents
- Section 1: About the controllers
- Section 2: Installing the controllers
- Section 3: Changing the room setpoint
- Section 4: Configuring the controllers
- Section 5: Balancing airflow
- Section 6: Application drawings
- Section 7: Sequences of operation
- Section 8: System integration and networking
- Appendix A: K-factors
- Index
Advanced options
The advanced options set up passwords and special features in the controller.
l Establish or change Password 1 and Password 2
l Set timers for standby and override (optional)
l Enable automatic occupancy (optional)
l Enable discharge air temperature control (optional)
l Calibrate the sensor
Setting the advance options requires entering Password 2 which is described in the topic
Getting started with configuration on page 24.
Tip: Once the following procedure is started, all steps must be completed in order.
Procedure Steps STE display
1 Starting display
1. Start at the temperature display.
2. Press the and buttons together.
l If Password 2 is not required, the display
changes to CNFG.
l If required, enter Password 2. The display
changes to CNFG when Password 2 is
correct.
72
12S1
PSW2
OOOO
2 Select the advanced
display.
1. From the CNFG display, press the
Set
Point
button to
show the STPT display.
2. Press the or buttons to change the
display to ADVC.
3. Press the
Set
Point
button to select ADVC.
CNFG
STPT
ADVC
Table 4–1 Procedure to set the advanced options
SimplyVAV Section 4: Configuring the controllers
Revision G 35