Install Instructions

Getting started with configuration
For access to the configuration functions you will need Password 2.
l If the controller has not been previously set up, no password is required.
l A new Password 2 can be entered or changed in the advance functions. See the topic
Advanced options on page 35.
Procedure Detailed steps STE display
1 Starting display
1. Start at the temperature display.
2. Press the and buttons together.
l If Password 2 is not required, the display
changes to CNFG.
l If required, enter Password 2. The display
changes to CNFG when Password 2 is
correct.
72
12S1
2 Enter Password 2.
1. Press the and buttons together and
hold them down until the display changes to
PSW2.
2. Press the or button to change the first
digit.
3. Press the
Set
Point
button to select the next digit.
Repeat for all four digits.
4. When the button is pushed for the fourth
correct digit, the display changes to COMM.
Note: If Password 2 has not previously been
entered the display will change to the CNFG
display after Step 1.
PSW2
OOOO
3 Select a configuration
function.
Access to the configuration functions always start
at the
CNFG
display.
CNFG
Enter the configuration mode
Section 4: Configuring the controllers KMC Controls, Inc.
24 Revision G