Install Instructions
Table Of Contents
- Contents
- Section 1: About the controllers
- Section 2: Installing the controllers
- Section 3: Changing the room setpoint
- Section 4: Configuring the controllers
- Section 5: Balancing airflow
- Section 6: Application drawings
- Section 7: Sequences of operation
- Section 8: System integration and networking
- Appendix A: K-factors
- Index
S ect i on 3: Changi ng t he room se t point
This section covers topics for the end user in a facility.
Changing the SimplyVAV user functions with an STE-8001 or STE-8201 are limited to
changing the active setpoints in a room. The setpoints are entered or changed using the
buttons and display on the front of the sensor.
Quick start to changing setpoints
1. Press any button to begin changing setpoints.
2. If required, enter Password 1.
3.
Press the up or down buttons to change a
setpoint value.
4.
Press the
Set
Point
button to save the value or
advance to the next function.
To enter or change the active setpoints you may need Password 1.
Tip: Once the following procedure is started, all steps must be completed in order.
Procedure Steps STE display
1 Starting display
Start from the temperature display.
72
12S1
2 Enter Password 1.
1. Press any button. The display changes to
PSW1.
2. Press the or buttons to change the first
digit.
3. Press the
Set
Point
button to select the next digit.
Repeat for all four digits.
PSW1
OOOO
Changing room setpoints
SimplyVAV
Revision G 21