Installation Guide

Managing a KMC Conquest AFMS
About the AFMSModule
The KMCCommander AFMS module allows you to configure, control, tune, and monitor the operation of a
KMCConquest Airflow Measurement System (AFMS). The icon appears in KMCCommander's side navigation bar
after an AFMS controller is discovered and saved in Networks Explorer.
Prerequisites
1.
Install a KMCConquest AFMS (the controller and all system components).
Note: See the Airflow Measurement System Installation Guide, found on any AFMScontroller's
product page.
2.
Select the application (on the AFMScontroller) needed for the equipment.
Caution: Select the application before configuring other settings. Changing applications after
configuration will restore most parameters to their defaults. See "Selecting an Application" in the
KMCConquest AFMS NetSensor Application Guide, found on any AFMScontroller's
product page.
Note: Complete basic configuration using a Conquest NetSensor, KMC Connect software, TotalControl
software, and/or the KMC Converge module for Niagara WorkBench.
3.
Set the AFMScontroller's communication parameters.
Note: See the above note on the basic configuration methods.
4.
In Networks Explorer, discover, save, and assign a profile (with trended points) to the AFMScontroller.
Note: For details, see the Discovering Devices and Assigning Device Profiles topics on KMCCommander
Help.
Setting Up an AFMS
To set up an AFMSusing the KMC Commander AFMS module, complete the following processes in this order:
1.
Setting AFMS Parameters on page 4
2.
Calibrating the AFMS's Sensors on page 6
3.
Running AFMS Learning Mode on page 7
Note: In environmental conditions where you can't run Learning Mode, see Manually Entering Damper
Characterization Data
on page 14.
KMC AFMS Commander Application Guide 3 AG230215A