Manual

Totest thefunctionof theforwarddrive bail,lift the bailto the handle
andreleaseit. The bailshouldreturnto its neutralposition.Ifit doesn't,
contactCustomerSupportfor assistanceorthe nearestdealer.
4. Snapthe cablehousingclips intothe handleassemblycable
mount.The redclip (reversecable)fits into thetop positiononthe
handleassembly,whilethe blackclip (forward/clutchcable)feeds
intothe lowerpositiononthe handleassembly.See Figure3.
Red
Reverse
Figure3
Clipthe cablesintothe cableguideslocatedon the handle
assemblypanelas seenin Figure4.
MOVING THE TILLER OFF THE SKID
To rollthetiller off the shippingplatform,putthewheelsinfreewheel,if
theyarenot alreadyfromthe factory,as follows:
1. Placea sturdyblockunderthe transmissionto raiseonewheel
about 1"off the ground.Removethe clickpin fromthe wheelhub
andwheelshaft.SeeFigure5.
f
Click Pin
Remove the click pin
from the wheel hub.
(WHEEL DRIVE position)
Slide the wheel fully
inward on the wheel shaft.
Reinstall the click pin.
(Freewheel position)
Figure5
2. Slidethe wheelfullyinwardonthe wheelshaft. Reinstallthe click
pinthroughthe wheelshaftonly (notthroughthe wheelhub). See
Figure5. Thewheel shouldnow spinfreely(freewheel)onthe
wheelshaft.Repeatwiththeother wheel.
3. Usethe handlebarto lift andpullthe tillerbackwardsto a flat
area.
NOTE:Beforestartingthe engine,thewheelsmustbe placedinthe
WHEELDRIVEposition(pinsthroughwheelhubsandwheel shaft).
Thisprocedureisdescribedinthe operationsectionunderwheeldrive
pins.
Figure4
J
8