Manual

4. Snapthe cablehousingclips intothe handleassemblycable
mount.The redclip (reversecable)fits into thetop positiononthe
handleassembly,whilethe blackclip (forward/clutchcable)feeds
intothe lowerpositiononthe handleassembly.See Figure3.
5. Clipthe cablesintothe cableguideslocatedon the handle
assemblypanelas seenin Figure4.
MOVING THE TILLER OFF THE SKID
Torollthe tiller offthe shippingplatform,putthe wheelsinfreewheel,if
theyarenotalreadyfromthe factory,as follows:
1. Placea sturdyblockunderthe transmissionto raiseonewheel
about1"off theground.Removetheclick pinfromthe wheelhub
andwheelshaft.SeeFigure5.
2. Slidethewheelfullyinwardon the wheelshaft. Reinstallthe click
pinthroughthe wheelshaftonly (notthroughthe wheelhub).See
Figure5. The wheelshouldnowspinfreely(freewheel)on the
wheelshaft.Repeatwiththe otherwheel.
3. Usethe handlebarto liftand pullthetiller backwardstoa flat
area.
NOTE:Beforestartingthe engine,the wheelsmustbe placedinthe
WHEELDRIVEposition(pins throughwheelhubsandwheelshaft).
Thisprocedureis describedinthe operationsectionunderwheeldrive
pins.
f
Figure4
f
Click Pin
Remove the click pin
from the wheel hub.
(WHEEL DRIVE position)
Slide the wheel fully
inward on the wheel shaft.
Reinstall the click pin.
(Freewheel position)
Figure3
Figure5
J
8