Manual

TINES
Thetineswill wearwithuseand shouldbe inspectedat the beginning
of eachtillingseasonandafterevery30 operatinghours.Thetines
can bereplaced.Referto the PartsListsectionof thismanualforpart
numbers.
Tine inspection
Withuse,the tineswill becomeshorter,narrowerandpointed.Badly
worntineswill resultina lossof tillingdepth,andreducedeffective-
nesswhen choppingupandturningunderorganicmatter.
Removing/Installing a Tine Assembly
1. Atine assemblyconsistsof a lefthandfineanda righthandfine.
NOTE:Thesharpedgesof the tinesarepositionedtoenterthe soil
firstwhen rotating.Notethispositionof the tinesfor reinstallationof the
newfine assemblies.
2. To removeafine assembly,simplyremovethe cotterpin securing
theclevis pinfor eachfine.SeeFigure29.
3. Removethe clevispin foreachfine,and slidetheassemblyto the
outsideof the unitandoff of the fine shaft.
4. Beforereinstallingthe fineassembly,inspectthe tine shaftfor
rust, roughspotsorburrs.Lightlyfile or sand,as needed.Applya
thincoatof greaseto the shaft.
5. Installeachtine of theassemblyso thatthecutting(sharp)edge
of the tineswill enterthe soil firstwhenthe tiller movesforward.
Clevis Pin
Figure29
J
22