User's Manual

12
PC REMOTE CONTROL
The integration of MERCURY LUX PC Software allows the user to operate the amplifier from a PC.
The Software has essential commands and visualization for a comfortable and safe operation and gives
you access to Reset Alarm, Alarm Message Operate/Standby, and FWD. REF. SWR. D-CURRENT Meters.
It also shows selected antenna and operating band.
The PC Software is compatible with all versions of Microsoft Windows.
Start Guide.
1. Make sure MERCURY LUX is powered OFF.
2. Connect a USB cable from the PC to the USB port
type (B) of the Amp.
Note: Turn ON the amplifier, the PC can already be ON.
3. Find the new port assigned by the amplifier interface.
It normally appears as (Serial Device).
Note: You can see the port in the device manager section
of Microsoft Windows.
4. Start MERCURY LUX PC software.
5. Click the COM button and select the corresponding
port. Note: If the communication is successful, the
temperature reading will be displayed on the main
screen.
Recommended. Use shielded USB cables, place 2
ferrite clamps at the end closest to the amp and PC.