Operation Manual

• Connect the amplifier to a 120 or 240-volt AC outlet; the power supply is AUTO sensing.
• Connect the output of the amplifier ANT-1 to a 50-ohm load or the corresponding antenna.
• Connect the RF-IN of the amplifier to the RF-OUT of transceiver.
• Connect the RCA PTT terminals from amplifier and to transceiver.
• Do NOT connect ALC unless it has been adjusted…(not needed for quick startup).
• Set the transceiver to the minimum power.
• Gradually increase power by SSB modulation, while checking for output power.
WARNING: Input power less than 35-watts for (RTTY, CW, AM, FM, DATA) Modes.
QUICK START GUIDE
5