Operation Manual

13
ANTENNA SWITCHES
The setup button (2) displays the automatic antenna selection board. Configure the
three antenna outputs with your antennas. The configuration remains in memory. At
powerup Antenna 1 is the default. Reset button restores all bands to antenna 1.
Main screen / Setup button / Ant config button.
.
You can manually select one of three antenna outputs (1). This
selection is not kept in memory once the amplifier is turned off.
1.
2.
NOTE: Even though the PA’s protection will trigger a REF POWER alarm, it is
always recommended to have an antenna or 50-ohm load connected to the
programmed output in order to avoid probable severe damage to components
.