Product Manual

Page 7 of 14
To use in the Full Assembly configuration, follow these instructions. If the Leveling Feet are attached
to the welded Table Top Frame (short legs), remove the four feet and set aside.
1. Assemble the Long Leg (3) and Leg Brace (4). Place the Leg Brace in the upright position. Slip all
four Leg Braces (4) into the holes on the Long Leg. It has 4 different height holes. Note: Use the
same height holes to make sure the Leg Brace will be on the same level.
2. Place the Table Top (1) upside down on a sturdy surface. Set the leg assembly over the Table
Top, making sure the mounting holes on the leg assembly align with mounting holes on the Short
Legs and Table Top Bottom Frame. The Bolts (7) will be through the inside holes on the Short
Legs and the inside holes on the Table Top Bottom Frame. Tighten the Bolts (6) and Nuts (7).
3. Tighten all Screws. Screw the Leveling Feet (5) into the bottom hole on each Long Leg.
4. Place the assembled table in the upright position. Adjust the Leveling Feet as needed to level the
table. When the Table Top is level, turn it upside down again, and tighten the Nuts (8) to lock the
Leveling Feet into position.