Product Manual

Page 6 of 14
Specific Operation Warnings
⚠WARNING
 Always wear the proper protective equipment including ANSI Z87.1 compliant eye protection, a
welding helmet, and welding gloves.
 Do not exceed the rated load capacity of 600 lb.
 Never sit or stand on the welding table.
 Use only on a level, hard surface.
 Inspect before each use. Do not use if parts are damaged.
 Keep the table clean for optimal performance. Wipe away dust and debris from the table top and
legs.
 Not for use by or around children.
Main Parts of Table and Kit
Subassembly
Table Top
Long Leg
Short Leg
Clamp
Accessory Bag
Assembly Instructions
The table may be used in two configurations:
1. Tabletop only (set on top of level, sturdy surface), such as a workbench.
2. Full assembly, with four table legs attached for stand-alone use.
The four Leveling Feet can be used with either configuration for proper leveling of the table.
To use in the tabletop-only configuration, place the Tabletop (1) upside down on a sturdy surface.
1. Screw the four Short Legs (2) into the side hole on each corner on the bottom frame using the 8
piece Bolts (6) and 8 piece Nuts M8 (7). Note: Only screw in the outside bottom corner.
2. Screw the four Leveling Feet (5) into the bottom hole on each Short Leg of the Tabletop Frame.
Place the Tabletop assembly in the upright position, and adjust the Leveling Feet as needed to
level the Tabletop.
3. When the Tabletop is level, turn it upside down again, and tighten all four Nuts M10 (8) to lock the
Leveling Feet into position.