Product Manual

Page 10 of 14
Operating Instructions
⚠WARNING
 Always wear the proper protective equipment including ANSI Z87.1 compliant eye protection, a
welding helmet, and welding gloves.
 Do not exceed the rated load capacity of 600 lb.
 Tighten all bolts before adding load.
 Be aware of dynamic loading! Sudden load movement may briefly create excess load causing
product failure.
 Never sit or stand on the welding table.
 Use only on a level, hard surface.
 Inspect before each use. Do not use if parts are damaged.
 Keep the table clean for optimal performance. Wipe away dust and debris from the table top and
legs.
 Use only for the intended purpose. Do not sit or stand on the table.
 Use ONLY on a flat, level, and hard surface.
 Not for use by or around children.
After Each Use
⚠WARNING
Wipe external surfaces of the table with a clean cloth.
Store the table in a dry place.
Maintenance
Maintain the table and kit by adopting a program of conscientious repair and maintenance in
accordance with the following recommended procedures. It is recommended that the general
condition of any tool be examined before it is used. Keep your tool in good repair. Keep handles dry,
clean, and free from oil and grease. The following chart is based on a normal operation schedule.
Maintenance Interval
Maintenance Point
After daily use
Wipe external surfaces of the table with a clean cloth.
Periodically
Check for any loose hardware and tighten.