Product Manual

Page 7 of 16
Assembly
To avoid a dangerous sudden release of pressure that can cause severe injury, ensure that the
pressure source for the reel is turned off and the supply hose is not pressurized.
Note: Before beginning assembly/installation, purchase appropriate hardware for mounting the reel.
The mounting base has four 1/2” (13mm) holes for mounting on a suitable flat surface.
Note: For wall mounting: Install the reel at most 5 feet (1.5m) above the floor.
1. Prior to mounting the hose reel, ensure that the supply hose pressure does not exceed the
maximum working pressure of the hose reel. Also check that the pressure source is turned off and
the supply hose for the reel is not pressurized.
2. Unpack the reel then check that all parts are present and inspect for damage. Check reel function
for smooth rotation.
3. Fasten the mounting base (1) in the desired location. (If desired, the base can be disconnected
from the two bracket assemblies (3 & 19), the base mounted, then the brackets and reel
reattached.) Reel dimensions and the pattern of the mounting holes in the base are shown below.
Tighten all hardware securely.