Product Manual

Page 21 of 25
Failure
Possible Cause
Corrective Action
Cannot Create an Arc
Work piece is painted or rusty.
Remove all paint and rust.
Ground clamp is connected
where there is paint or rust.
Remove all paint and rust so the
ground clamp is connected to bare
metal.
Ground clamp is not
electrically connected to the
work piece.
Make sure the ground clamp is
connected to the work piece.
The Process Selector Switch
is in the wrong positon.
Make sure the Stick/TIG selector
switch is in the STICK position.
Electrode Holder or
Ground Cable is Getting
Hot. Output Connections
are Getting Hot
Weld cable connections are
loose.
Check to make sure weld cables are
tight.
Weld cable connections have
corroded.
Clean weld connections and reinstall.
Poor Welding
Performance. Excessive
Spatter
Damp electrode.
Use fresh and dry electrodes.
Electrode Sticks
The electrode is kept in
contact with the work piece for
too long while striking an arc.
This will take practice; keep trying.
Welding Bead Is Too Thin
The welding travel speed is
too fast.
Reduce the welding travel speed.
Incorporate a slight weave over the
joint.
Welding Bead Is Too Thick
The welding travel speed is
too slow.
Increase the welding travel speed.
For Assistance, Contact the Welder Help Line at 877-304-0294