Product Manual

Page 8 of 12
3. Lock the two hooks (4).
After Each Use
⚠WARNING
Wipe external surfaces of the table with a clean cloth.
Maintenance
Maintain the table by adopting a program of conscientious repair and maintenance in accordance with
the following recommended procedures. It is recommended that the general condition of any tool be
examined before it is used. Keep your tool in good repair. Keep handles dry, clean, and free from oil
and grease. The following chart is based on a normal operation schedule.
Maintenance Interval
Maintenance Point
After Daily Use
Wipe external surfaces of the table with a clean cloth.
Periodically
Check if the hardware is loose. If so, tighten.
Troubleshooting
Use the table below to troubleshoot problems before contacting service personnel or your local
dealer. If the problem continues after troubleshooting, call your local dealer for assistance.
Failure
Possible Cause
Corrective Action
The welding table
stands unevenly.
The screws are loose.
Check and tighten all hardware.
The feet are uneven.
Adjust the feet until the table is steady.