Product Manual

Page 4 of 22
Intended Use
The Klutch P600iHD is a heavy-duty, 60 amp, DC inverter plasma cutter. Its intended use is for
cutting through steel, stainless steel, aluminum, and other metals. This unit is designed to cut up
to 7/8" steel (sever cut) at a travel speed of 10 inches per minute, when operating on 230V AC
power. Plasma cutting does require a source of compressed air and this unit in particular requires
a compressed air source that can provide 60 PSI at a rate of 4.5 CFM. Compressed air supply
should not exceed 100 PSI.
Plasma cutting is an alternative to oxygen/acetylene cutting. Since plasma cutting does not
require flammable and combustible gases, it is considered a safer alternative to oxygen/acetylene
cutting. The plasma arc is designed to cut through metal and does so efficiently, providing a clean
cut edge.
This unit is intended to be used on a 50 amp 230V AC circuit without the use of an extension cord.
If an extension cord is necessary for your application, use the appropriate size and length of
extension cord that will handle the required input amps the entire length of the extension. We
highly recommend talking with a qualified electrician for cord size recommendations. This unit is
supplied with a NEMA Class 6-50P plug and will require a NEMA Class 6-50R receptacle. Do not
remove the power plug!
Accessories Included:
(1) 12 ft. Removable plasma torch
(1) 10 ft. Ground cable/clamp
(3) Extra electrodes
(3) Nozzles