Product Manual

Page 12 of 22
Reference
Subassembly
1
Air-Pressure Gauge
2
Output Amperage Control
3
Compressed Air Connection (Back Panel)
4
Air-Pressure Control Knob
5
Indicator Lights
6
Ground Cable Connection Receptacle
7
Ground Cable and Clamp
8
Torch Trigger Connection Receptacle
9
Torch
10
Torch Power Connection Receptacle
11
Torch Arc Start Connection Receptacle
12
Electrodes and Nozzles
Setting Up Equipment
⚠WARNING
ELECTRIC SHOCK CAN KILL!
 High voltage danger from power source! Consult a qualified electrician for proper installation
of receptacle. This plasma cutter must be grounded while in use to protect the operator from
electrical shock.
 Do not remove grounding prong or alter the plug in any way. Use only the supplied adapter
between the plasma cutter's power cord and the power source receptacle. Make sure the
POWER switch is OFF when connecting your plasma cutter’s power cord directly to a properly
grounded 230 VAC, 60 HZ, Single Phase, 60 amp input power supply.
1. POWER REQUIREMENT 230V - AC single phase 230V (200-240V) 50/60 HZ fused with a 60
amp time delayed fuse or circuit breaker is required. DO NOT OPERATE THIS UNIT if the
ACTUAL power source voltage is less than 215 volts AC or greater than 240 volts AC.
2. EXTENSION CORD - We do not recommend extension cords because of the voltage drop
they produce. This drop in voltage can affect the performance of the plasma cutter. If you
need to use an extension cord, check with a qualified electrician and your local electrical
codes for your specific area.
3. INSTALLATION OF THE CUTTING TORCH - Your torch should be fully assembled and
ready to install. Figure 2 shows the components of the torch head and how those components
are installed.