Product Manual

Page 10 of 22
⚠WARNING
Shielding Gas Cylinders Can Explode
High pressure cylinders can explode if damaged, so treat them carefully.
 Never expose cylinders to high heat, sparks, open flames, mechanical shocks, or arcs.
 Do not touch the cylinder with the torch.
 Do not cut on the cylinder.
 Always secure cylinder upright to a cart or stationary object.
 Keep cylinders away from welding, cutting, or electrical circuits.
 Use the proper regulators, gas hose, and fittings for the specific application.
 Do not look into the valve when opening it.
 Use a protective cylinder cap whenever possible.
⚠CAUTION
Proper Care, Maintenance, and Repair
 Always have power disconnected when working on internal components.
 Do not touch or handle the PC board without being properly grounded with a wrist strap. Put
the PC board in a static-proof bag to move or ship.
 Do not put hands or fingers near moving parts, like the drive rolls of a fan.
⚠WARNING
Proposition 65 Warnings
 Plasma cutting equipment produces fumes or gases which contain chemicals known to the
state of California to cause birth defects and, in some cases, cancer (California Health &
Safety code section 25249.5 et seq.).
Specifications of P600iHD
Item
Specification
Power Supply
230V, 42A, 50/60 Hz, Single Phase
No-Load Voltage
310V DC
Output Range
20 - 60A DC
Duty Cycle
30% @ 60A
Compressed Air Required
4.5 CFM @ 60 PSI - DO NOT SUPPLY MORE THAN 100 PSI
Dimensions
18-5/8” x 7-3/8” x 13-1/2”
Weight
30 lb.