Product Manual

3
IMPORTANT SAFETY CONSIDERATIONS
1. Do not use for medical purposes.
2. Do not open the housing other than battery compartment.
3. Avoid direct Eye exposure.
4. Do not expose the tool to rain or wet conditions.
5. Stay alert, watch what you are doing and use common sense when operating the tool. Do
not use while you are tired or under the influence of drugs, alcohol or medication. A
moment of inattention may result in serious personal injury.
6. Do not use the tool if the Trigger does not turn it on and off. Any tool that cannot be
controlled with the Trigger is dangerous and must be repaired.
7. Disconnect the battery before making any adjustments, changing accessories, or storing
the tool. Such preventive safety measures reduce the risk of activating the Laser accidentally.
8. Maintain the tool. Check for misalignment or binding of parts, breakage of parts and any
other condition that may affect the tool's operation. If damaged, have the tool repaired
before use. Many
accidents are caused by poorly maintained tools.
9. Use the tool in accordance with these instructions, taking into account the working
conditions and the work to be performed. Use of the tool for operations different from those
intended could result in a hazardous situation.
10. Have your tool serviced by a qualified repair person using only identical replacement
parts. This will ensure that the safety of the tool is maintained.
11. Position batteries in proper polarity and do not install batteries of different types, charge levels,
or capacities together.
12. This product is not a toy. Keep it out of reach of children.
FUNCTIONS
4
INSTALLING THE BATTERY
Remove the battery cover and insert two AAA batteries into the unit, following indicated polarity.
Place the battery cover back.
Caution:
If you do not plan to use the thermometer for a month or more, remove the battery.
Batteries can leak chemicals that can destroy electronic parts.
OPERATION
Note: Do not expose this product to strong electromagnetic fields, such as those generated by an
arc welder, induction heater, etc.
Note:
When moving the Thermometer to an area with significantly different ambient temperature,
allow the unit to adjust to the new ambient temperature for 30 minutes before use.
1. Squeeze the Trigger to activate the Laser and temperature reading.
2. Push the °F/°C button to toggle between Fahrenheit to Celsius, and to recover the last reading
when in OFF mode.
3. Squeeze the Trigger and move the laser to see a constant temperature reading and max
reading.
4. Release the Trigger to display the most recent temperature reading, or to allow approx 20
seconds for auto shut off.
5. Non-reflective surfaces will yield a more accurate reading than reflective surfaces. Duct tape
(sold separately) can be applied to reflective surfaces in order to get a better measurement.
Allow sufficient time for the tape to match the temperature of the surface it is applied to before
trying to get a reading
.
6. The object being tested should be larger than the size calculated by the Field of View diagram,
below.
7. When finished, release the Trigger. The last temperature will display approximately for 20
seconds, then the unit will shut off.