Product Manual

Page 8 of 58
Always replace or repair damaged components before using the welder.
• Check all components to ensure they are clean and in good operating condition before use.
⚠CAUTION
During Operation
Do not operate the welder if the output cable, electrode, torch, or any accessories are wet. Do
not immerse them in water. These components and the welder must be completely dry before attempting
to use them.
• Follow the instructions in this manual.
• Keep the welder in the OFF position when not in use.
• Connect ground lead as close to the area being welded as possible to ensure a good ground.
• Do not allow any body part to come in contact with the welding electrode if you are in contact with
the material being welded, ground, or electrode from another welder.
• Do not weld if you are in an awkward position. Always have a secure stance while welding to prevent
accidents. Wear a safety harness if working above ground.
• Do not drape cables over or around your body.
• Wear a full coverage helmet with appropriate shade (see ANSI Z87.1 safety standard) and safety
glasses while welding.
• Wear proper gloves and protective clothing to prevent your skin from being exposed to hot metals,
UV, and IR rays.
• Do not overuse or overheat your welder. Allow proper cooling time between duty cycles.
• Keep hands and fingers away from moving parts.
• Do not point the torch at a body part of yours or anyone else’s.
• Always use this welder in the rated duty cycle to prevent excessive heat and failure.
⚠WARNING
Electrical Shock
Electric arc welders can produce a shock that can cause injury or death. Touching electrically live
parts can cause fatal shocks and severe burns. While welding, all metal components connected to the
wire are electrically hot. Poor ground connections are a hazard, so secure the ground lead before
welding.
• Wear dry protective apparel: coat, shirt, gloves and insulated footwear.
• Insulate yourself from the work piece. Avoid contacting the work piece or ground.
• Do not attempt to repair or maintain the welder while the power is on.
• Inspect all cables and cords for any exposed wire and replace immediately if found.
• Use only recommended replacement cables and cords.
• Always attach the ground clamp to the work piece or worktable as close to the weld area as possible.
• Do not touch the welding wire and the ground or grounded work piece at the same time.