Product Manual

Page 53 of 58
Failure
Possible Cause
Corrective Action
Creating
Excessive
Spatter.
Ground clamp is not electrically
connected to the work piece.
Make certain the ground clamp Is
connected to the work piece.
Trigger Is not pressed.
When in the MIG mode, this unit is not
electrically hot until you press the
torch trigger.
Stick or TIG welding and machine is
set for MIG welding.
Make certain the SPOOL GUN/MIG
TORCH/STICK WELDING selector
switch is in the STICK position.
The contact tip is too large.
Make certain the correct contact tip is
installed.
Torch liner is plugged.
Clear or replace torch liner.
No shielding gas.
Connect shielding gas supply and turn
shielding gas on.
MIG torch is not correctly installed and
shielding gas is not transferring to the
arc.
Remove and reconnect the MIG torch
to make certain it is completely
installed into the MIG connector.
Wire speed setting is incorrect.
Refer to the label inside the wire
compartment door for wire speed
setting recommendations.
Voltage setting is incorrect.
Refer to the label inside the wire
compartment door for voltage setting
recommendations.
For Assistance, Contact The Welder Help Line at 877-304-0294