Product Manual

Page 50 of 58
9.3 Twist the torch to make contact between the work piece and the tungsten.
9.4 Lift torch away from the work piece about 1/8 inch.
9.5 Move down the joint to be welded by pushing the torch.
9.6 Insert filler metal in the leading edge of the weld puddle as needed.
10. To operate using Foot Pedal follow steps in DC TIG OPERATION on pages 49-50 in this
manual.
10. Follow these steps for striking an arc using the Foot Pedal while TIG welding.
10.1 Open the shielding gas valve on the torch handle to begin gas flow.
10.2 Hold torch away from the work piece about 1/8 inch.
10.3 Press Foot Pedal in to start welding arc
10.4 Move down the joint to be welded by pushing the torch.
10.5 Insert filler metal in the leading edge of the weld puddle as needed.
After Each Use
⚠CAUTION
Hot Materials - Welded materials are hot and can cause severe burns if handled improperly.
• Do not touch welded materials with bare hands.
• Do not touch the torch nozzle after welding until it has had time to cool down.
1. Turn OFF the power switch when not using the equipment.
2. Turn OFF any shielding gases you may have used during the operation of this equipment.
3. Inspect all cords and power cables. Replace any cords or power cables that are damaged or
cracked.
4. Disconnect and organize welding cables so they are protected while not in use.