Manualshelf

Product Manual

ManualsBrandsKlutch ManualsMIG + Flux Core WeldersInverter-Powered Multi-Process Welder with LCD, MIG Torch and Lift Start TIG Torch — Inverter, MIG, Flux-Cored, Stick and TIG, 230V, 15–250 Amp Output
21222324252627282930
Page 24 of 58
1. Remove the ground cable and the electrode holder from the weld output connections. Install
the ground cable to the Positive (+) weld output connection (Figure 8).
2. Secure the ground clamp to the work piece.
3. Connect a regulator to a bottle of ARGON gas. Then connect the gas connection from the TIG
torch to the regulator.
4. Connect the TIG torch weld cable to the Negative (-) weld output connection.
5. Set the desired amperage on the amperage control knob on the front panel of the welder.
6. Turn on the input power switch on the welder.
7. Turn on the regulator on the bottle of shielding gas and adjust the regulator to approximately
20 CFH. Open the shielding gas valve on the torch to start the flow of shielding gas.
Before Each Use
⚠WARNING
ELECTRIC SHOCK CAN KILL!
• Touching live electrical parts can cause fatal shocks or severe burns. Do not touch live electrical
parts.
• Wear dry, hole-free insulating gloves and body protection.
• Disconnect input power before installing, maintaining or servicing this equipment. Lockout/tag out
input power according to OSHA 29 CFR 1910.147.
1. Review the contents of this manual and follow all safety warnings and cautions.
2. Inspect all cords and power cables. Replace any cords or power cables that are damaged or
cracked.
3. Make certain your equipment is in good working order.
4. Make sure the area is clean, dry, and ventilated. Do not operate the welder in humid, wet, or
poorly ventilated areas.
5. Always be aware of your work environment. Be sure to keep other people, especially children,
away from you while welding.
Operating Instructions
⚠WARNING
High voltage danger from power source!
• Consult a qualified electrician for proper installation of receptacle at the power source. This welder
must be grounded while in use to protect the operator from electrical shock. If you are not sure if
your outlet is properly grounded, have it checked by a qualified electrician. Do not cut off the
grounding prong or alter the plug in any way and do not use any adapter, other than the supplied
adapter, between the welder's power cord and the power source receptacle. Make sure the power
switch is OFF, then connect your welder's power cord to a properly grounded 230 VAC (220V -
240V), 60 HZ, single phase, 50-amp power source.