Manualshelf

Product Manual

ManualsBrandsKlutch ManualsMIG + Flux Core WeldersInverter-Powered Multi-Process Welder with LCD, MIG Torch and Lift Start TIG Torch — Inverter, MIG, Flux-Cored, Stick and TIG, 230V, 15–250 Amp Output
21222324252627282930
Page 23 of 58
3. Carefully slide the gas connector and the weld power connection through the weld cable access
opening in the front of the machine (Figure 10).
Figure 10
4. Open the wire compartment door.
5. Connect the gas connection quick connector to the gas connector (1) on the back panel of the
wire compartment.
6. Connect the weld power connection to the bolt on the top of the MIG connector (2).
7. Connect the 5-Pin trigger connector to the 5-Pin receptacle for the spool gun, on the front of
the machine (3).
8. Make sure the SPOOL GUN option has been selected in the LCD control program.
OPTIONAL DC STICK WELDING ASSEMBLY
⚠CAUTION
Be aware that the ELECTRODE HOLDER will be electrically HOT when the Input Power Switch on the
welder is turned ON.
1. Install the ground cable quick connector to the Negative (-) Weld Output Connector (Figure 3).
2. Secure the ground clamp to the work piece.
3. Install the electrode cable quick connector to the Positive (+) Weld Output Connector.
4. Make certain the STICK MODE option has been selected in the LCD control program.
OPTIONAL TIG TORCH ASSEMBLY
⚠CAUTION
Be aware that the TIG TORCH will be electrically HOT when the Input Power Switch on the welder is
turned ON.