Product Manual

Page 22 of 58
Figure 8
3. Insert the back end of the MIG torch into the MIG socket on the front of your machine (Figure
8). Make certain to completely slide the torch all the way in. Slightly twist to assist with pushing
the torch to the back of the receptacle. The retaining bolt can then be tightened, making certain
the bolt sets down into the retaining groove on the back of the MIG torch.
4. Connect the 5-Pin trigger connection on the MIG torch to the 5-Pin trigger receptacle for the
MIG torch on the front panel (Figure 8).
5. Connect the ground cable to the Negative (-) weld output connection for MIG welding. If welding
with self-shielded flux core, connect the ground cable to the Positive (+) weld output connection
and move the Weld Power Cable to the Negative (-) weld output connection.
SPOOL GUN ASSEMBLY
1. This unit is set up to accept a spool gun.
2. The spool gun has three connection points at the back of the spool gun (Figure 9).
1) The gas connection is a slide-on quick connector.
2) The weld power connection has a round ring connection.
3) The trigger connection is the 5-Pin snap-on connector.
Figure 9