Product Manual

Page 20 of 58

Reference

Subassembly

Gas Bottle Valve

Gas Flow Gauge (Set at 20 CFH)

Gas Pressure Gauge

Regulator

Gas Flow Adjuster

Gas Hose Connection

Gas Cylinder

Figure 6

iv. Connect the other end of the gas hose to the gas hose connection on the

supplied regulator/flow gauge. Use a wrench to snug up the connection.

v. Before installing the regulator, it is good practice to make certain no debris is

in the gas bottle connection. Rotate the bottle so the gas connection is not

pointing toward you or any other person. Turn the valve on the gas bottle

clockwise and quickly close. This quick thrust of gas will clear any debris in the

connection. Connect the regulator to the gas bottle connection. Use a wrench

to snug up the connection.

vi. Open the Gas Bottle Valve on the cylinder of gas.

vii. Turn the Gas Flow Adjuster on the regulator so that the gas flow rate is set at

approximately 20 CFH. Make certain you are reading the correct scale on the

gauge.

NOTE: Slowly open the cylinder valve by turning it counterclockwise until the

cylinder pressure gauge registers on the first gauge of the regulator. Turn the

adjustment knob clockwise (right) slowly to increase gas flow to 20 CFH. To

reduce the gas flow, turn the adjustment counterclockwise (left). The gas valve