Manualshelf

Product Manual

ManualsBrandsKlutch ManualsMulti Process WeldersMIG Welder with Multi-Processes, Spool Gun, LCD Display and Dual-Voltage Plug — Inverter, MIG, Flux-Cored, Arc and TIG, 120V/230V, 40 to 200 Amp Output
21222324252627282930
Page 23 of 47
Operating Instructions
⚠WARNING
High voltage danger from power source!
Consult a qualified electrician for proper installation of receptacle at the power source. This welder
must be grounded while in use to protect the operator from electrical shock. If you are not sure if
your outlet is properly grounded, have it checked by a qualified electrician. Do not cut off the
grounding prong or alter the plug in any way and do not use any adapter, other than the supplied
adapter, between the welder's power cord and the power source receptacle. Make sure the power
switch is OFF, then connect your welder's power cord to a properly grounded 230 VAC (220V -
240V), 60 HZ, single phase, 50 amp power source. If operating on 120V, attach the 120V Adapter
cord to the unit power cord and then connect the assembly to a properly grounded 120 VAC
(110V-130V), 60 Hz, single phase, 25 amp power source.
UNDERSTANDING THE FRONT PANEL
Reference
Description
1
LCD Display
2
Gas Purge Button
3
Wire Jog Button
4
Voltage Control Knob
5
Multi-Function Adjustment/Selection Knob
6
Previous Screen Button
7
Start Button