Product Manual

Page 11 of 18
Operating Instructions
• To use the adjustable knob to change the speed; there are five section speeds: The first
section speed 15,500 RPM. The second section speed 14,500 RPM. The third section speed
13,000 RPM. The forth section speed 11,000 RPM. The fifth section speed 10,000 RPM.
• Release the throttle control lever to stop the tool.
 Replace the sanding belt.
Disengage and remove the sanding belt from the idle pulley after pushing the idle pulley in
the direction. Replace a new one and keep your hand away from the idle pulley. Push the
tension bar indicated on the drawing and the sanding belt will be free to be removed and
replaced.
After Each Use
• Disconnect the air supply from the tool.
• If you are not using a lubricated air supply, lubricate the tool.
• Store the tool.