Product Manual

Page 15 of 31
Before Each Use
To avoid injury from accidental starting, always turn the switch OFF and unplug the drill press before
installing or removing any accessory or attachment or making any adjustment.
Make the following adjustments before each use of the drill press.
1. Table Adjustment
A. Height adjustment
To adjust the table up or down:
Loosen the locking handle then adjust the table to your
desired height suing the table bracket crank handle. See
Fig. 11
B. Tilting adjustment:
Loosen the locking handle then tilt the table to the desired
angle and retighten the handle. See Fig. 12
C. Swing adjustment
Loosen the locking handle then rotate the table to a desired
position and retighten the handle. See Fig. 13
2. Feed Depth Adjustment
2.1 Loosen the locking screw; rotate scale so desired depth is
indicated on scale nest to the pointer. Tighten locking screw.
Use this feature to drill more than one hole to same depth.
2.2 Spindle can be locked in either fully or partially down
position. Loosen locking screw. Lower chuck to desired
depth, rotate scale fully clockwise and tighten locking screw.
Use this feature to set up and align work.
3. SPEED ADJUSTING
The spindle speeds shown in the speed label. To change the speed, loose the belt tension lock
knob , pull the motor mounting plate to the front end then change the belt location. To tighten
the belt, push the motor mounting plate to the rear end and lock the belt tension lock knob.
See Fig.15
4. Quill Spring Adjustment
The quill return spring may need adjustment if the tension causes the quill to return too rapidly or
too slowly. See Fig. 16