Product Manual

Page 14 of 31
3. Install the table and rack
a. Take the retaining ring off and table bracket.
b. Install the table support and bracket. See Fig. 2 and the parts list.
c. Reinstall the retaining ring and secure it firmly. See Fig. 3
4. Install the crank handle and table. See Figs 4 and 5 and the parts list.
a. Fix the crank handle with the attached screw
b. Tighten the clamp bolt to lock the table bracket.
c. Place the table onto table support. See Fig. 6
5. Installing the head assembly
a. Carefully lift the head assembly above the column and slide it onto the
column. Make sure the head slides down over the column as far as
possible. Align the head with the base.
b. Using the hex wrench, tighten the head lock set screws. See Fig. 7
6. Installing the feed handles
a. Locate the three feed handles in the loose parts bag.
b. Screw the feed handles into the threaded holes in the hub and tighten
them. See Fig. 8
7. Before any assembly of the chuck and arbor to the drill press head, clean
all mating surfaces with a non-petroleum based product; such as alcohol or
lacquer thinner. Any oil or grease used in the packing of these parts must
be removed; otherwise the chuck may come loose during operation.
8. Install the chuck
a. Open the jaws of the chuck by rotating the chuck sleeve clockwise. To
prevent damage, make sure the jaws are completely receded into the
chuck.
b. Push the chuck onto the spindle.
NOTE: Clean the spindle taper with a non-alcohol based cleaner before
inserting it into the chuck.
c. Using a wood mallet, firmly tap the chuck upward into position on the
spindle shaft. See Fig. 9
9. Install the knob and screw of upper pulley cover. See Fig.10