Product Manual

Page 19 of 21
Part No. Description Quantity
53 Crank Arm 1
54 Link Arm 1
55 Bearing 61900 2
56 Bolt Pin 1 1
57 Bolt Pin 3 1
58 Bearing 6001 4
59 Push/Pull Assembly 1
60 Inner Hex Screw M8X55 1
61 Lower Cover Plate 1
62 Cross Head Twist Bolt M8X20 2
63 Track 1
64 Compaction Ram 1
Troubleshooting
Problem Solution
Curbing Machine will not turn on
• Make sure the Power Switch is in the “ON” position.
• Make sure to use the proper size extension cord.
• Make sure the extension cord is connected to a working,
115 volt, grounded, electrical outlet.
• Have a qualified service technician examine the
machine.
Curbing Machine extrudes poorly.
• Make sure to properly mix the cement, sand, and water.
• Make sure the Slip Form is properly attached to the
machine.
• Make sure to properly feed the Hopper.
• Make sure the Compaction Ram is moving freely on its
Track.
• Make sure the Crank Arm has been properly adjusted
(length and stroke of the Compaction Ram) for the job at
hand.
• Have a qualified service technician examine the
machine.
Replacement Parts
• For replacement parts and technical questions, please call Customer Service at 1-800-222-5381.
• Not all product components are available for replacement. The illustrations provided are a
convenient reference to the location and position of parts in the assembly sequence.
• When ordering parts, the following will be required: model number, serial number/lot date code,
and description.
• The distributor reserves the rights to make design changes and/or improvements to product lines
and manuals without notice.