Product Manual

Page 15 of 25
Before Each Use
To avoid injury from accidental starting, always turn the switch OFF and unplug the drill press before
installing or removing any accessory or attachment or making any adjustment.
Make the following adjustments before each use of the drill press.
1. Table adjustment
a. Height adjustment
To adjust the table up or down, loosen the table lock handle (20) then adjust the table to your
desired position by turning the table bracket handle (19). (Fig.8)
b. Swing adjustment
Loosen the table lock handle (20) then rotate the table to a desired position and retighten the
lock handle.(Fig.9)
1. Feed depth adjustment
a. Depth control stud type depth
Lower the spindle assembly to the desired depth and spin down the nut. If the nut moves due
to vibration, spin down the 2nd nut and lock it in position by holding the lower nut and tighten
the upper nut.
b. Depth control scale sleeve type
Loosen the clamp bolt and lower the spindle assembly to the desired depth then retighten the
bolt.(Fig.10)