Product Manual
Page 7 of 12
4. Connect the RED power clip to a POSITIVE 12 volt source, BLACK power clip to a NEGATIVE
ground point.
5. Test the connections by switching the inflator to “on”. Air will begin to flow.
6. Connect the air hose by screwing the brass inflator onto the tire valve stem. Only finger tighten
the inflator. Do not use any tools as you may damage the inflator or the valve stem.
7. Watch the gauge closely and switch the product off or remove the inflator from the tire when the
manufacturer’s recommended pressure has been achieved.
Stopping and Restarting
High pressure can overload and blow the in-line fuse. At higher inflation pressures, start the product
and then attach the filler to the tire valve stem. If you stop the unit and need to resume inflation,
remove the inflator tip from the tire valve, start the product, and reattach with the product running.
Overheating Protection Circuit
The air inflator is equipped with an automatic protection device. In the event that the product reaches
an unsafe operating temperature, a protection circuit will cut power to prevent damage to the product.
If the protection circuit activates, immediately disconnect the product from the power source and allow
it to cool down.
The product will cool in approximately 15 minutes, depending on the environmental conditions. The
protection circuit will automatically reset when the temperature returns to a safe operating level.
After Each Use
⚠WARNING
Only hold the unit by the carry handle and allow the unit to cool before storing.
Store the product in a dry location.
Replace the valve cover on the stem.
Troubleshooting
Use the table below to troubleshoot problems before contacting service personnel or your local
dealer. If the problem continues after troubleshooting, call your local dealer for assistance.
Failure
Possible Cause
Corrective Action
Product stops
running during
operation.
Low voltage.
Check the battery condition.
Protective circuit is activated.
Disconnect the power and wait for the
product to cool down.
Air is leaking.
Brass inflator is not fully extended.
Fully extend the brass inflator.