Product Manual

Page 7 of 11
air inflator and into a 12V vehicle socket. Only one cable at a time should be plugged into the
inflator. Do not try to draw power from multiple sources.
2. Place the inflator’s connector valve tightly onto the tire and close the thumb latch. Make sure air
is not leaking through. Open the start-up switch and turn the power switch ON. Air will begin to
flow through the hose.
Note: When inflating a tire, pay close attention to the indicator in the gauge. Two to three minutes
is enough time for the tire to reach the rated air pressure.
3. After reaching the rated air pressure, turn off the switch and remove the nozzles and plug.
Inflating Bicycle Tires, Toys, Air Mattresses, and Sport Balls
1. This unit provides two power options. The AC cable plugs into the air inflator’s AC 110V socket
and plug into a standard 110V wall plug. The 12V DC cable inserts into the 12V socket on the
air inflator and into a 12V vehicle socket. Only one cable at a time should be plugged into the
inflator; do not try to draw power from multiple sources.
2. Be sure the nozzles fit the inflatable objects.
3. Turn the power switch ON and pay close attention to the pressure gauge. Turn the inflator OFF
when the object is fully inflated.
Note:
 The product can be used with either an 110V AC power source or a 12V DC power
source. Only attempt to use one type of power source at a time.
 Inflate up to 12 minutes and allow the unit to cool down. Resting the unit for 10 minutes
will help prolong the life of the inflator.
After Each Use
⚠WARNING
 Only hold the unit by the carry handle and allow the unit to cool before storing.
 Store the product in a dry location.
Troubleshooting
Use the table below to troubleshoot problems before contacting service personnel or your local
dealer. If the problem continues after troubleshooting, call your local dealer for assistance.
Failure
Possible Cause
Corrective Action
Product does not
operate.
Poor connection between plug and socket
1. Gently turn the plug in the cigarette
lighter socket until contact is made.
2. Check the plug and socket for
obstructions.
Power supply fuse blown
Check the cigarette lighter power supply
fuse.
Product runs but
does not inflate.
Poor connection on the valve
Ensure the adaptor is pushed firmly onto
the valve before locking it into place.
Air leaking
1. Check the item for leaks.
2. Ensure the hose does not have breaks
or leaks at the fitting.
Product runs too
slowly.
Overheating
Disconnect the power and wait for the
product to cool (approx. 10 min).
Voltage is too low
Check the condition of the battery.