Instructions

*The full range of accessories and electronics is available at www.KlusDesign.eu

www.KlusDesign.eu

NOTE! All LED tapes must be connected to a 12 V or 24 V power supply.

IMPORTANT: Not all possible mounting procedures are presented here.

More mounting procedures and related accessories can be found at www.KlusDesign.eu.

Drawings of extrusions and accessories in these instructions are simplied and only

approximate the actual shapes.

K-10-WL Fastener – mounting instructions

1. K-10-WL Fastener (ref. 42672)

2. Wire*

3. Wall fastener*

4. Power supply (12 V / 24 V)*

5. Lighting xture*

PAGE 1
K-10-WL Fastener – mounting instructions 3. 2. 4. 1. 5. 1. K-10-WL Fastener (ref. 42672) 2. Wire* 3. Wall fastener* 4. Power supply (12 V / 24 V)* 5. Lighting fixture* *The full range of accessories and electronics is available at www.KlusDesign.eu NOTE! All LED tapes must be connected to a 12 V or 24 V power supply. IMPORTANT: Not all possible mounting procedures are presented here. More mounting procedures and related accessories can be found at www.KlusDesign.eu.
PAGE 2
K-10-WL Fastener – mounting instructions I Mount the fasteners (1) on the wires (2) and on the wall fasteners (3). 3. It is recommended to use: 2. 2 fasteners for 1 m of fixture 4 fasteners for 2 m of fixture 5 fasteners for 3 m of fixture 3. 1. 2. 1. Connect the lighting fixture (5) to the 12 V / 24 V power supply (4) and snap it in the fasteners. II 4. CLICK! 5. CLICK! www.KlusDesign.