User's Manual

Klover Products Inc.
5807 W Fenrick Rd, Janesville, WI 53548
[phone] - support @KloverProducts.com
Step 4 - Install Mic Yoke
The thumb screw should be on bottom, small targeting screws on top, and arrows in both end plates
pointing up. Remove second end plate from the microphone yoke, slide the first end plate onto locator
pins, then place second end plate onto locator pins on opposite side of dish and snap into place.
(If the end plates have been removed you may have to switch the two end plates in order to properly
align them. There are small flats on the connectors that should match. They should both be horizontal
or both vertical.)
Step 5 - Focus microphone - Option #2 –
If you prefer, you can also position the center of the microphone pickup 1 1/2” behind the front surface
of the dish using a tape measure. Be careful to avoid scratching the inside surface of the dish.
US Patent #9014402