Owner Manual

Table Of Contents

U-clamp installation（wrench 10mm）:

1. Wrap the zipline around the finishing tree, then use 2 U-clamps （①②）to lock the cable.

Note:

a. Al I clamps must be added with washers when used, then lock clamps as shown above: b.When you wrap your zipline

around the finishing point tree, it should be formed a

tear drop

shaped wrap around the tree-see illustration

below. Do not tighten up tight against the tree!

CORRECT cable wrap Tear-drop Shaped

2.Wrap the cut-end back and use three U-clamps （③，④，⑤）to lock.